Super Sonic Guitar Build - Part 2
Creating templates and learning how to use the router table.
 |
| Broke down and bought a neck template |
 |
| Cut the body template and sizing it up on the body blank |
 |
| Shot of the three piece ash body blank |
 |
| Duplicating the template |
 |
| I was having a hard time getting micro adjustments out of my spring loaded router. I grabbed my car jack and it works great! |
 |
| Duplicating the duplicate on to 1/2 mdf |
 |
| This should be easier to run on the router |
 |
| Sloppy rough cut with my hand held jigsaw. I should have spent more time getting it closer to the line. |
 |
| Tape and super glue makes double sided tape substitute |
 |
| Some pretty big chipout. I should have watched more videos. |
 |
| Laying out the neck blank |
 |
| routing the truss rod |
 |
| Close up shot |
 |
| Used some wood filler in the chip out areas. I think it came out great for my first try. |
 |
| Rough cutting the neck. Getting as close as I can to the line. |
 |
| All cout out |
 |
| I didn't get a shot where I filed and sanded closer to the line. This is right after cutout. |
 |
| Routed out great! Again, not bad for a beginner. |
 |
| Rounded over the body with a 7/16 round over bit |
 |
| Looking more like a guitar body |
